4.2 Cutting Procedure for ESS 2000 Rubber Skirt Seals
Caution:
Ensure that the following procedure is carried out in a safe position away
from the conveyor belt. This procedure is to be undertaken in conjunction
with the Safe Working Practices outlined in this Installation Manual.
Any installation of equipment, and any equipment installed must comply with
AS 1755-2000 Conveyors – Safety requirements.
The following steps are recommended for the safe cutting of ESS Snug-Fit and Square
Edge rubber skirt seals:
Step 1 Measure and mark the required length of ESS 2000 skirt rubber for the job being
undertaken. A white paint marker is recommended, and the mark should be
perpendicular to the length of the rubber.
Step 2 Place the rubber in a vice, or firmly clamp it to a suitable piece of structure.
Position the cut mark so that it is free and accessible for a cut to be made, and
that the rubber is free on one side of the mark.
Step 3 Have an assistant grip the free end of the rubber to prevent excessive movement,
and to open the cut as it progresses. Using a hacksaw with a fresh blade, slowly
begin to cut the rubber from the top of the mark.
A knife or sharp blade is not recommended due to the hazards involved.
Ensure that appropriate PPE is worn, including eye protection and suitable
gloves.
To Next Page
Loading...