- 29 -
“MenuàOptionàSystem Optionà advance Option”, press
“▲/▼”, select “ No. Card” as Y (es), the validating as follow.
In the starting-up windows. place the PIN card near induction area
( distance is not far, otherwise the card will not be detected) the
screen show as follow：
If use other way to register Mifare card (the example: The
registration fingerprint card), Set “No. card” option as Y (es), then
step same with above.
If Set No. card” option as N (O), then confirmation flow as follows:
In the initial interface, (distance is not far, otherwise the card will
not be detected), screen display as follows:
Place the finger on the sensor surface, the following appears：
Verify PIN Card
UserID 00008
Verified
Verifying FPCard
00009
Place Finger……
Any key to Cancel
Verifying FPCard
00009
Please move finger
Any key to Cancel
To Next Page
Loading...
