- 23 -
This operation procedure is same as above enroll new user
operation
Note: Where system memory permits, it is advisable to have at
least two fingers enrolled for a long-term user.
4.4 Authentication type
4.4.1 Fingerprint authentication
Use fingerprints to validate access authentication with the
following types:
（1）1：1 authentication（Verification）
In this mode, enter a pre-registered ID first and then a fingerprint.
The enrolled fingerprint corresponding to the ID will be compared
to the entered fingerprint on a 1:1 basis. The 1:1 authentication type
takes a short time regardless of the number of users. There is no
need to make any special settings in the system. After entering the
ID, enter the fingerprint to perform authentication.
Block
diagrams
Display
Enroll No 00009
ESC OK
New Enroll
Enroll No 00008
ESC OK
To Next Page
Loading...
