Option
n Ethernet: whether use TCP/IP protocol or not；
n RS232: whether use RS232 or not；
n RS485: whether use RS485 or not；
n Link code: it defaults to code is 0, but it can be set up.
n Extern Modem：This item is set as Y(es), this fingerprint
machine may connect with additional Modem
n USB : The use of USB communication, if you use USB
communications, it would be the choice is "Yes", otherwise
voted "No"
Note：
1) If the fingerprint machine is provided with “Getaway”
and “Sub mask”, the” Ethernet” Option will not exist in it,
which is defaulted as Ethernet is in opening; If the
fingerprint machine is not provided with “Getaway” and
“Sub mask”, the “Ethernet” Option will exit in it, if you
want to use Ethernet, this Option must be set as Y(es).
2) After setting，be sure to restart fingerprint machine, so
the configuration take effect.
To Next Page
Loading...
