Install And Connect TV
Set your TV
To put your TV in a rm place which can bear the weight of the TV.
To avoid danger, please don’t expose the TV near water or heating place
(such as light, candle, heating machine),do not block the ventilation at
the back of TV.
Connect antenna and power
1. Connect the antenna cable to the antenna socket on the back
of the TV.
2. To plug the power cord of TV (AC 100¬240V- 50/60Hz).
Turn on TV
3. Press the power button of the TV the indication light will turn to
green, if it is on standby mode (the light is red), press the power
button on the remote control to turn on the TV.
Note: Picture for reference purposes only.
1. Open the carton and remove the TV and scattered
accessories and base (some models without base).
2. to avoid the injury of the TV, covered with a soft
mattress, put it on the table, face down on a soft
mattress, the base of the neck is xed on the TV with
screws.
3. screw the base and connected to the TV.
4. the installation is complete.
Note:
Picture for reference purposes only.
Please prevail in kind
TV Stand Installation Instructions
To Next Page
Loading...