6
CLEANING &
MAINTENANCE
1. Wipe machine exterior with soft, slightly dampened cloth daily before starting
operations.
2. If necessary, a mild, non-corrosive cleaning agent may be applied to the cloth.
DO NOT spray cleaning agents directly on the machine body to avoid corrosion and
possible damage to circuits.
1. Rinse the handle with hot water after each brewing cycle to dissolve residual oils in the
filter basket and outlet nozzle and prevent oils from affecting the quality of coffee.
2. Disassemble filter basket handle and filter basket. Immerse both in cleaning solution
(3tsp of detergent in 1 pint hot water) for 24 hours to dissolve residual coffee oils.
DO NOT immerse plastic portion in cleaning solution to avoid deterioration.
3. Rinse all components with clean water. Wipe with a soft, clean cloth only.
1. After each brewing cycle, remove the handle and press the manual water output button
to remove all residual coffee grounds from the filter element.
2. Then fix the handle to the seat again
CAUTION:
DO NOT force handle or fix it into the seat too tightly.
3. Press the manual water output button, shake the handle to clean the handle seat gasket
and remove residual coffee grounds from the inside.
4. Flush the steam outlet in REVERSE daily before shutting off the machine.
5. Remove the copper plate and filter element from the water outlet.
WARNING:
Metal may be hot.
6. Place a reverse flushing silica plate in the filter cup, and apply about 2-3 grams of
detergent. Fix the handle into the seat and check for tightness.
7. To dissolve residual detergent in the machine, press the manual water output button for
approximately 4 seconds and release. Repeat this process several times. Press the manual
water output button and shake the handle to clean the gasket and the inside of the
brewer. Continue the process until water in the filter cup is clear and clean.
8. After cleaning, remove the handle. Press the manual water output button to allow
residual cleaning solution in the brewing system to flow out. Turn water off after flushing
for about one minute.
a. During reverse flushing, remove and wash the copper plate and filter element
with clean tap water. Wipe with soft cloth.
b. If process is unable to sufficiently clean the plate and filter element,
immerse the components overnight in a mild cleaning solution of 3 tsp detergent
in 1 pint hot water.
9. Rinse and reassemble components before restarting the espresso machine.
MACHINE BODY
BREWING SYSTEM
FILTER BASKET & BASKET HANDLE
To Next Page
Loading...
