5
OPERATION
1. Fill the porta filter with coffee grounds and tamp.
2. Secure the port filter to the espresso machine with a quarter turn.
3. Use any of the presets to brew or use the continuous flow button.
4. If using continuous flow, the brewing will continue until it is pressed again, stopping the
brewing process.
1. Press the first and fifth buttons simultaneously to start automatic reverse flushing.
Output buttons 2-4 in the control panel will light and start automatic reverse flushing
from the right output system to the left.
2. The default is 10 cleaning cycles.
3. If you want to stop before the completion of all 10 cleaning cycles, press button 3.
4. Flush the group after flushing the group. Or press the 3rd output button to skip to the
next output system, System will stop automatically after finish all the reverse flushing.
1. After cleaning the machine, remove all liquids and solid matter from the water tray.
2. Turn off the power.
3. Open steam knob to release steam flow. Do not place any liquid under the steam tube
during this process in to avoid system contamination.
BREWING
AUTOMATIC REVERSE FLUSHING
STOPPING THE MACHINE
• Reverse Flushing is recommended daily.
To Next Page
Loading...
