Estun E21S - Page 17

E21S Operation Manual
14
<Note>: When the system is on run status, the operation of manual
adjustment is just valid for the X-axis.
- If the drive mode of the corresponding axis is frequency:
Press Key
Status
Direction
Running Time
Speed
Stop
increasing
Press time
Slow
Run
Cannot do it
Stop
decreasing
Press time
Slow
Run
Cannot do it
+
Stop
increasing
Press time
Fast
Run
Cannot do it
+
Stop
decreasing
Press time
Fast
Run
Cannot do it
Step 3 Click return to single step parameter setting page.
----End