Need help?Do you have a question about the ESX Signum SX-4120 and is the answer not in the manual?
Instructions for physically mounting the amplifier unit using provided screws.
Details for connecting ground, remote, and power wires to the amplifier.
Controls for Low Pass, High Pass filters, and Crossover selection.
Controls for input level, mode selection, twin sub, and bass boost.
Status LEDs, RCA outputs, and remote control connections.
Guide for connecting and configuring front/rear speakers in a 4-channel setup.
Guide for connecting and configuring two subwoofers in twin sub mode.
Guide for connecting front speakers and subwoofer in a 3-channel configuration.
Troubleshooting for power-on failures, no signal, and low output problems.
Guidance on resolving hiss, white noise, and electrical interference.
Explains protection circuits and actions to take when they engage.
To Next Page
General
