Need help?Do you have a question about the ESX VE 1800.1 and is the answer not in the manual?
Covers grounding, remote turn-on, battery connection, and the purpose of the Maxi-Fuse for protection.
Instructions for connecting a single subwoofer to the amplifier and setting relevant controls.
Instructions for connecting two subwoofers to the amplifier and setting relevant controls.
Details on wiring two amplifiers in Master/Slave mode to a single subwoofer and setting controls.
Explains the red display light indicating protection mode and its common causes like overheating or short circuits.
General| Channels | 1 |
|---|---|
| RMS power at 1 ohm | 1800W |
| Low pass filter | 30Hz - 250Hz |
| Subsonic filter | 10Hz - 50Hz |
| Frequency response | 10Hz - 250Hz |
| Signal-to-noise ratio | >90dB |
| THD at 4 ohms | <0.1% |
| Input sensitivity | 0.2V - 6V |
| Damping factor | >200 |
| Fuse rating | 200A |
| Input Impedance | 10k ohms |
| Bass boost | 0 - 12dB |
To Next Page
