Et DRIVE 1000 - Receiver Information

28
Receiver Setup
Receiver programming and setup.
Receiver informaon.
From Standby status
- “Selected” mode -
- Standby
The gate can be in any posion when performing this roune.
Acon
Response
Descripon Display Buzzer Gate
To enter the program
menu. Press and hold the
 buon unl buzzer
beeps.
Display and buzzer
conrms.
Programming menu
<or> for opons
Scroll < or > to select the
receiver setup opon.
Display scrolls
through opons.
Receiver Setup
<  = change >
With “Receiver Setup”
on the display, press and
release .
Display shows
receiver setup
opons.
Receiver Setup
Quick learn
Scroll < or > to select the
Receiver info opon.
Display changes
respecvely.
Receiver Setup
Receiver info
With “Receiver info” on the
display, press and release
.
Display begins
toggling between
the number of user
addresses used out of
the total memory and
the soware version.
Receiver Info
used: 1 of 1023
-----------------------
Receiver Info
Soware ver: 2
Press and release X to exit
back to receiver setup
opons.
Display changes back
to main receiver
setup opons level
and buzzer beeps.
Receiver Setup
Receiver info
x2
Scroll le or right to next
program opon.
OR
“Selected” mode
- Standby
EXIT back to standby
status
x1