Et DRIVE 1000 - Installing the Baseplate

9
Baseplate and fastener kit assembly.
2
1
1
3
2
3
2
3
2
3
3
4
5
3
4
5
6
7
Diagram
number
Descripon
1
Custom cup bolts for fastening
the gearbox to the baseplate.
2 M10 Nylock nuts.
3 M10 Flat washers.
4 M10 Machine nuts.
5
M10 J-Bolts for concrete casng
method.
6 Cabling conduit piping.
7 Baseplate.
Installing the baseplate.
There are a number of dierent fastening techniques that can be used to fasten the baseplate in posion. The standard kit is supplied with J-bolts
so that the baseplate can be cast in concrete. While this method oers a nice solid base it takes more than 48hrs to install as the concrete must cure
properly before connuing with the installaon. Whichever mounng method you opt for, the posion of the base plate will always remain the same.
Here are the dimensions to use when posioning the base plate. The baseplate should be installed above the highest point of ooding that may occur
with the run o of water down the driveway.
Proudest component of
the gate on the motor side
Edge of the baseplate
nearest to the gate
Required space
30 - 50mm
Gate positioned where the proudest component
is opposite the base plate of the operator.
Base plate positioned on the opposite
side of the gate guide/emergency post,
to the driveway.
Gate guide/
emergency post
PLAN VIEW OF THE BASEPLATE INSTALLED
Driveway
Required space
> 50mm to allow for
the optional security
bracket.
Cable inlet.