EN - 53
EN
4.2 CHARGER STATION INSTALLATION
1.
Place the charging station on the oor. Make sure there is enough space on the sides of
the base (at least 0.5 m) and in front of the base (at least 1.5). Not necessary power cable
length can be stored in cable storage D5. Don´t expose the charging dock to sunshine.
2. Connect the adapter to the charging station and then to the wall outlet. (the indicator
lights up D1). Not necessary power cable length can be stored in cable storage D5.
5. VACCUM CLEANER USE
Remark
The device has voice notication function which can be set in various languages
(this function can be deactivated).
Insert the battery into the remote control, observe correct polarity (2 pieces, battery type AAA)
.
5.1 SWITCHING ON THE VACUUM CLEANER
1. Press button C1 for approx. 3 seconds.
2. First you hear voice message about loading of the system, then the message about
successful switching on the device (light signalisation is on).
Note
Factory setting of voice messages in English.
5.2 BATTERY CHARGING
1.
Check that the charging station is properly connected to the mains. (light D1 must be on).
2. Position the device near the charging dock and press C2 button on the device or F8
on the remote control. If the battery is too low, place directly and correctly the vacuum
cleaner on the charging station.
To Next Page
Loading...
Need help?
General
