EN - 54
EN
Remarks
– Standard charging time is approx. 4-6 hours. Fully charged battery will work for
approx. 230 minutes, depending on set functions.
– The stated operating times are based on ETA‘s internal testing and only apply
to a new and fully charged battery. Depending on the age and wear of the battery,
the operating time decreases.
– After cleaning, the vacuum cleaner will automatically search for the charging station.
– The "ETA SMART" application makes it easy to nd out the battery status. The
application can also be sent back to the charging station at any time.
5.3 START / STANDBY MODE
Start (Cleaning)
Press C1/C2 on the control panel or F1/F2/F6 buttons to start the device.
Standby mode (Pause)
Press the C1 button on the control panel or the F1 button on the remote control to interrupt
the ongoing cleaning and put the vacuum cleaner in standby mode.
Notes
The robot vacuum must start cleaning from the charging dock. Put the charging dock
on a suitable place in accordance with the instructions and do not change its location
so that the robot vacuum can easily nd it.
5.4 CLEANING MODES AND DEVICE FUNCTIONS WITHOUT USING THE
ETA SMART APPLICATION
Manual operation
You can operate the device manually using F2 direction buttons and clean only the areas
where cleaning is necessary.
Smart automatic cleaning
Press the C1 button on the control panel or the F1
button on the remote control. During cleaning, the
vacuum cleaner moves gradually and systematically
in the space according to the programmed route. It
divides the space into individual segments. As soon as
the vacuum cleaner cleans the entire available space,
it automatically searches for the charging station. This
is the most used method of cleaning
To Next Page
Loading...
Need help?
General
