Reflector Housing Assembly 9
Reflector Housing Assembly
Removing reflector
Tools Required:
• Minimally padded work surface (cardboard, carpet, or rubber mat recommended)
1: Place the reflector housing face down on your work surface so that the concave reflector surface
points downward.
2: Loosen the clutch and rotate the yoke so that it is perpendicular to the housing at roughly a 90°
angle. Tighten the clutch.
Reference
Number
Part
Number
Description
Quantity
Required
1 7060A3054 Housing, reflector casting, painted black 1
2 7060A3006 Clip, reflector retainer 4
3 7060A4010 Bushing, gate 4
4 7060A3016 Plate, clutch 1
5 7060A3019 Spring, reflector support 1
6 7060A4015 Reflector, molded glass, coated 1
7 7060A3058 Bracket, yoke, painted 1
8 HW8144 Handle, yoke knob, 5/16 - 18 2
9 HW753 Rivet, machine, 3/16 x.720, flat head, black zinc 2
10 HW5126 Washer, flat, 5/16, black zinc 4
11 HW5193 Bolt 5/16-18 x 3/4, black zinc 2
12 HW5125 Bolt, carriage, 5/16-18 x.75, black zinc 2
13 HW752 Rivet machine, 3/16 x 5/16, black zinc 4
14 7060A4088 Label, S4 750w UL 1
WARNING:
This procedure may crack or break the reflector. Always wear gloves, safety
glasses, and a dust mask when performing this procedure.
Figure 9
7
1
8
10
4
11
9
6
5
12
3
2
13
(2 required)
(4 required)
(4 required)
(4 required)
14
8
10
To Next Page
