EasyManua.ls Logo

Etec DVA286 - Page 11

Etec DVA286
29 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
36. STEP
37. RAN (RANDOM)
REMOTE CONTROL
Loading Batteries
1. Remove the Battery Compartment Cover
-------------------------------------------------------------------------------
2. Insert Batteries
Make sure to match the Positive “+” and Negative “-“ ends of the batteries to
“+” and “-“ marks inside the battery compartment.
---------------------------------------------------------------------------------
3. Replace the battery compartment cover
IMPORTANT Notes On Batteries
Do not insert batteries into the remote control in the wrong direction.
No not discard batteries into a fire.
Do Not Use Different Types Of Batteries Together or Mix Old And New Batteries.
If The Remote Control Does Not Function Correctly Or The Operating Range Becomes
Reduced, replace all Batteries With New Ones.
OPERATING THE REMOTE CONTROL
When using the remote control, the front of the remote should always be
directly at the infrared sensor on the player front panel. For proper operation,
always use the remote within an angle of ± 30 degrees and a range of less than
30” feet
.
Notes On The Remote Control
Point The Remote Control At The Remote Sensor on the front of the
Do Not Drop Or Subject The Remote Control To hard Shocks.
Do Not Leave The Remote Control in or Near an Extremely Hot / Humid
Place.
Do Not Spill Water Or Leave Anything Wet On The
Control.
Do Not Disassemble The Remote Control.