6.2 DYNAMIC RANGE
DYNAMIC RANGE: When LINE OUT is selected, choose this setting to adjust the line out ratio
and get different effect. If adjusting to FULL, the audio signal peak value will be the minimum. If
adjusting to OFF, audio signal peak value will be the maximum.
6.3 DUAL MONO
DUAL MONO: If your amplifier/decoder has Dolby Digital output, you may select stereo, left
mono, right mono, or mixed mono mode for your amplifier decoder.
TROUBLESHOOTING
Please refer to the following guide for the possible cause and solution for a problem before
contacting the nearest service center or dealer for repairs.
To Next Page
Loading...