To Next PageTo Next PageWhy is my Eternity Plus Water Heater water not hot enough?
If your Eternity Plus Water Heater isn't producing hot enough water, several factors could be at play. You may need to check for cross-plumbing between the cold and hot water lines. Also, ensure the gas supply valve is fully open. The gas line and gas supply pressure should be properly sized and adequate, respectively. Lastly, verify that the set temperature isn't set too low.
What to do if hot water is not available when a fixture is opened with Eternity Plus Water Heater?
If you're not getting any hot water from your Eternity Plus Water Heater when you open a fixture, consider these potential solutions: * Ensure the unit has a 240V 50Hz power supply. * If using a remote controller, check if it's powered on. * Confirm that both the gas and water supply valves are fully open. * Inspect the cold water inlet filter for cleanliness. * Make sure the hot water fixture is open sufficiently to allow at least 3.0l/min of water flow through the heater. * Check if the unit is frozen or if there's enough LPG in the bottle (for propane systems).
Why does hot water get cold and stay cold with Eternity Plus M26 Water Heater?
If the hot water from your Eternity Plus Water Heater suddenly turns cold and stays that way, here's what you can check: * Ensure the flow rate is sufficient to keep the water heater running. * Verify the gas supply valve is fully open. * Inspect the cold water inlet filter to ensure it's clean. * Check your fixtures for any debris or obstructions.
Why is there fluctuation in hot water temperature with Eternity Plus M26?
If you're experiencing temperature fluctuations with your Eternity Plus Water Heater, consider the following: * Check if the filter on the cold water inlet is clean. * Ensure the gas line is properly sized. * Confirm that the supply gas pressure is adequate. * Inspect for any cross-connections between the cold and hot water lines.
What to do if Eternity Plus M26 Water Heater does not ignite when water goes through the unit?
If your Eternity Plus Water Heater isn't igniting when water flows through it, try these troubleshooting steps: * Ensure the flow rate is above 3.0l/min. * Check the cold water inlet filter for blockages. * Inspect for any reverse or cross-connections. * If using a remote controller, make sure it's powered on.
Why does it take a long time to get hot water at the fixtures with Eternity Plus Water Heater?
The time it takes to get hot water from your Eternity Plus Water Heater to your fixtures depends on the length of the piping between them. The longer the distance or the larger the pipes, the longer it will take for the hot water to arrive.
What to do if Eternity Plus M26 Water Heater remote controller does not display anything when turned on?
If the remote controller for your Eternity Plus Water Heater isn't displaying anything when you turn it on, ensure that the unit has power supply and the connection to the unit is correct.
Critical safety warnings and general guidelines for installation planning and execution.
Precautions and considerations for choosing the correct and safe location for the water heater.
Minimum clearance requirements for outdoor heater locations based on AS/NZS 5601.1:2010.
Instructions for proper gas connection, sizing, and suitability checks.
Solutions for common problems related to hot water temperature and delivery amount.
Explanation of error codes displayed on the remote controller and their corresponding faults.
General| Brand | Eternity Plus |
|---|---|
| Model | M26 |
| Category | Water Heater |
| Language | English |
