16
5.1 REMOTE CONTROLLER INSTALLATION
WARNING
DO NOT locate the remote controls where they may come into contact with water.
DO NOT position the remote controls in the vicinity of chemicals.
DO NOT position the remote controls over a heat generating appliance (i.e. cooker, toaster)
DO NOT position the remote controls where materials may spill onto them.
PLEASE NOTE IF THE CONTROLS ARE TO BE FITTED TO A METAL SURFACE AN
INSULATION PLATE SHOULD BE PROVIDED BEHIND THE MOUNTING POSITION.
!
The remote controller comes with a 10m cable. If a longer cable is needed, please purchase a
shielding line. Cut the original line and rewire according to the polarity to avoid short circuit whilst
adhering to the requirements below:
●
Attach the remote control to the wall with screws supplied.
●
a. Minimum 18AWG wire
b. Maximum run of 60m
83mm
102mm
●
●
●
●
●
To Next Page
Loading...
