What to do if my ETNA Hob is not working and nothing appears on the display?
If your ETNA hob isn't working and the display is blank, the issue might be with the power supply. Please check the fuses or the electric switch to ensure they are functioning correctly.
Why does my ETNA Hob keep blowing a fuse when I switch it on?
If a fuse blows immediately when you switch on your ETNA hob, it's likely that the hob has been wrongly connected. You should check the electrical connections to ensure they are properly configured.
What to do if my ETNA KI560ZT Hob displays error code E3 or E4?
If your ETNA hob shows error code E3 or E4, it means the internal temperature of the hob is too high. Turn off the hob and allow it to cool down until the 'H' disappears from the display. Then, switch the hob back on. If the same error reappears, call an authorised service agent.
What to do if my ETNA KI560ZT displays error code E5 or E6?
When your ETNA hob displays error code E5 or E6, it indicates that the internal temperature is too high. Ensure the hob has enough ventilation and is correctly installed. Allow the hob to cool down, then try restarting it. Also, check if the fan is running smoothly; if not, contact a service technician.
What to do if my ETNA KI560ZT displays error code E1 or E2?
If your ETNA hob is showing error code E1 or E2, it indicates that the supply voltage or frequency is different from the rated values. Contact a certified installer.
Why do my pans make noise while cooking on the ETNA KI560ZT?
The noise from your pans while cooking on the ETNA hob is due to the energy flowing from the hob to the saucepan. At high settings, this is normal for some pans and will not damage either the pans or the hob.
What does it mean if my ETNA Hob display shows ‘u’?
If your ETNA hob displays 'u' when a cooking zone is switched on, it means that the pan you are using is not suitable for induction cooking or has a diameter less than 12 cm. Use a suitable pan.
Why does my ETNA KI560ZT have a slight smell when I use it for the first time?
A slight smell from your ETNA hob during the first few uses is normal because the new appliance is heating up. This smell will disappear after it has been used a few times. Make sure to ventilate the kitchen.
Why does the fan run after switching off the ETNA KI560ZT?
Normal operation.
Why does the display light up when the ETNA Hob is activated for the first time?
Normal operation.
To Next Page
General
