10.10 Timer
Thiscanbesettoeithercountupwardsfromzeroortocountdowntozero.When
active,thetimerwillbegincountingfromtherstthrottleapplication,andanaudible
warning will be heard when the timer reaches the limit that has been set. The warning
will sound for 10 seconds before stopping.
10.11 Battery Type
This feature requires use of the optional ET1156 and ET1159 Telemetry parts for correct
operation.
LiPo–UsetheJSTXHwiringharnessfromtheTelemetrysettosuityourbattery,
connect one end to the ‘Vol’ port of the telemetry module and the other to your bat-
tery. The system will automatically identify whether a 2,3,4,5 or 6 Cell pack has been
connected, and an audible warning will sound from the transmitter when the battery
voltage drops below 3.5v per cell. Please stop use of your model at this point to pre-
vent damage to the battery and/or ESC.
4Ni-Mh–Whenusingthissettingthetransmitterwilldisplaytheinputvoltageto
the receiver. An audible warning will be heard when the supply voltage to the receiver
drops below 4.4v
5Ni-Mh-Whenusingthissettingthetransmitterwilldisplaytheinputvoltagetothe
receiver. An audible warning will be heard when the supply voltage to the receiver
drops below 5.5v
10.12 Factory Reset
This will return all settings to factory default and lose all model memories. Please be
sure that you are willing to lose all previous settings before using this feature, as the
settings cannot be recovered.
10.13 Channel Adjust/Calibration
Over time the accuracy of the potentiometers used in transmitters can drift. The cali-
bration feature allows these to be reset to take that drift into account.
Once into the menu, press the ‘Enter’ key then follow the on-screen instructions to
complete the calibration process.
9
To Next Page
Loading...
General