10. Menu Functions
Navigating the menu:
From the Main Screen press the ‘Enter’ key, then use the ‘+’ and ‘-‘ keys to select the
function that you wish to use. Once selected use the ‘Enter’ key to access each sub
menu,thenusethe‘+’and‘-‘keystoreachthesettingyouwishtochange.Usethe
‘Enter’ key to highlight the setting, then use the ‘+’ and ‘-‘ keys to set the value you
wishtouse,thenusethe‘Enter’keytoconrm.Pressingthe‘Exit’keyatanypointwill
take you one step back in the process. Repeatedly pressing the ‘Exit’ key will return
you to the Main Screen.
10.1 End Point Adjustment (EPA)
The EPA is used to limit the servo travel to prevent it from straining and potentially
failing.Whenadjustingsteeringendpoints,ensurethe‘ST.D/R’dialonthetransmitter
is wound fully clockwise so the ‘D/R’ display on the Main Screen reads 120% before
making any adjustments.
Important – incorrect Dual Rate and End Point settings can reduce the life of servos
connected to your radio. If in doubt use slightly less travel.
10.2 Temperature
This feature requires use of the optional ET1156 and ET1157 Telemetry parts for correct
operation.
This menu allows the setting of the maximum temperature that the thermocouple can
record before an audible warning sounds, along with displaying the current tempera-
ture recorded by the thermocouple and the maximum temperature recorded since the
receiver has been switched on.
10.3 Channel Reverse
This allows the direction of servo travel to be reversed to suit the model it is being
installed in.
6
To Next Page
Loading...
General