Maintenance | 15
7. Insert one new battery into each battery holder, matching the
–/+ on the battery with the –/+ on the board. Slide the + end of the
battery into the appropriate end of the holder, and then press the
– end of the battery down until the entire battery is secure in the
holder.
TIP: To assist in inserting the battery into the holder, you might need
to pull the contacts slightly outward.
8. Replace the lid on the base, and insert and tighten the screws. Do not
over tighten.
For maximum battery life, fully charge the batteries before placing
them into service for the first time. Failing to fully charge the batteries
may result in reduced battery life and cause premature battery failure.
9. See page 42 for the steps to charge the new batteries.
To Next Page
Loading...
