ETS 6 - 1. OVERVIEW; 1.1 Product Features; 1.2 Package Content; 1.3 Cable Overview

1
1. OVERVIEW
1.1 Product Features
 Easy network setup with your iPhone / iPad
 1.3 / 2 Megapixel solution with HDTV 720p quality, allowing users to notice minor details more easily
 Solid light series featuring better overexposure prevention (Advanced Smart Light Control)
 ONVIF standard supported to simplify system integration
 POE (Power-over-Ethernet) support to eliminate the use of power cables and reduce installation costs
 IR LEDs built-in for night surveillance
 (For selected model only) External alarm I/O device connection
 (For selected model only) Equipped with a vari-focal lens of f2.8 ~ 12mm, suitable for various monitoring environments.
 (For selected model only) WDR to increase image recognizability in overexposure and dark areas.
 (For selected model only) Zoom lens of f6.0 ~ 60mm with 10x optical zoom, 10x digital zoom and auto focus, suitable for
various monitoring environments.
 (For selected model only) Micro SD card support for video storage.
 (For selected model only) Built-in heater which can operate at temperatures as low as -40℃.
 (For selected model only) Push Video to send event notifications to iOS or Android devices immediately
 Remote Surveillance
-- Full compatibility on iPhone & iPad, and Internet Explorer® on Windows® operating system
1.2 Package Content
 Standard Package
 IR Camera  Quick Guide
 Optional Accessories
 Screws & wall plugs  CD manual
 Wrench  Bracket
 Desiccant  Sun shield
 Installation sticker
1.3 Cable Overview
Cable Description
Power cable
Connect to DC12V power supply.
Note: The power adapter is optional.
RJ45 network cable
Connect it to the supplied RJ45 cable extender adapter for cable extension, and prepare
another RJ45 network cable with suitable length for your connection.
GND
Ground wire, used for reset default or external device connection.
Alarm-in*
Reserved for connecting to an external alarm device. For details, please refer the user
manual of your alarm device.
Alarm-out*
Reserved for connecting to an external alarm device. For details, please refer the user
manual of your alarm device.
RESET
Remove the insulating coating of this wire, and twist it with a ground wire together to reset
default. This will reset all parameters, including the IP address to factory default settings.
Note: Disconnect power before twisting these two wires together, and connect to
power again for reset default.
* For selected models only