EUCHNER CES-AP Series - Default Chapter; Table of Contents

Operating Instructions
Non-Contact Safety Switch CES-AP-C01-…
2
(Translation of the original operating instructions) 2112663-08-02/20
Contents
1. About this document ............................................................................................. 4
1.1. Scope ............................................................................................................................................ 4
1.2. Target group ..................................................................................................................................4
1.3. Key to symbols ...............................................................................................................................4
1.4. Supplementary documents ..............................................................................................................4
2. Correct use .......................................................................................................... 5
3. Description of the safety function .......................................................................... 6
4. Exclusion of liability and warranty ......................................................................... 6
5. General safety precautions ................................................................................... 6
6. Function ............................................................................................................... 7
6.1. Door monitoring output ...................................................................................................................7
6.2. Diagnostic output ...........................................................................................................................7
6.3. Limit-range monitoring ....................................................................................................................7
6.4. Switching states .............................................................................................................................7
7. Changing the approach direction .......................................................................... 8
8. Mounting .............................................................................................................. 9
9. Electrical connection .......................................................................................... 10
9.1. Notes about .........................................................................................................................11
9.2. Safety in case of faults .................................................................................................................. 11
9.3. Fuse protection for power supply ...................................................................................................11
9.4. Requirements for connecting cables ...............................................................................................11
9.5. Connector assignment of safety switch CES-AP-C01 ........................................................................ 12
9.6. Connection ................................................................................................................................... 13
9.7. Notes on operation with safe control systems .................................................................................15
9.8. Devices for direct connection to IP65 eld modules.........................................................................15
10. Setup ................................................................................................................. 16
10.1. LED displays ................................................................................................................................16
10.2. Teach-in function for actuator (only for unicode evaluation) ...............................................................16
10.2.1. Preparing device for the teach-in operation and teaching-in actuator ....................................16
10.3. Functional check ........................................................................................................................... 17
10.3.1. Electrical function test ......................................................................................................17
11. System status table ............................................................................................ 18