EUCHNER EKS Series - Command Overview; Status Numbers

Manual EKS Electronic-Key Adapter USB
Page 32/34 Subject to technical modifications 2094485-05-07/19
8.5 Command overview
Description
Command message
Reply message
Program Electronic-Key
TP (see chapter 8.4.1)
RF (see chapter 8.4.1)
Read Electronic-Key
(also read the serial number)
TL (see chapters 8.4.2 and 8.4)
RL (see chapter 8.4.2)
or
RF (see chapter 8.4.2)
8.6 Status numbers
Value
Description
00
hex
No error
02
hex
Electronic-Key not in the operating distance
03
hex
Parity bit error on read-only Electronic-Key
06
hex
Write process interrupted. Start address or number of bytes is not a multiple of the block size 4
17
hex
Read attempt when the Electronic-Key adapter is set to Electronic-Key read/write and a read-only
Electronic-Key is inserted
18
hex
Read attempt when the Electronic-Key adapter is set to read-only Electronic-Key and an Electronic-Key
read/write is inserted
4x
hex
General Electronic-Key communication error (renewed write or read process necessary)
50
hex
Write attempt despite enabled write protection