05
WARNING
5.Set the low voltage protection function:
Specific value refer to the table below:
This product has a low voltage protection function. When it detects that the battery voltage is
lower than the set value, it will automatically turn off the compressor to prevent over discharge
from damaging the battery or causing the car unable to start normally. At this time, the screen will
display "E1" code prompt. If the voltage returns to normal, the refrigerator will automatically enter
the working state one minute later. The factory default is "Medium". If you need to change it,
please follow the following steps:
a:Unlock control panel.
b:Long press the "set" button for 2 seconds, then press the "set" button one time. At this time, one
of the battery protection level icons "L, M, H" on the display will flash, and then press the "up/
down" button to change the setting.
6.Single and double temperature zone function:
This product has the function of automatically identifying the temperature zone. Inserting the
middle partition, the default is double temperature zone. The big zone is the freezing zone, and the
small zone is the refrigeration zone. At this time, the temperature of the freezing zone can be
adjusted by removing the middle partition as a single temperature zone, and the temperature is
subject to the actual set value.
If your refrigerator enters battery protection mode in advance, it may be because your power
supply voltage is insufficient and the low voltage protection value is set too high, or your DC
power supply wiring is improper and cannot provide enough current. Check whether the power
supply wiring is sufficient, and consider appropriately lowering the battery protection gear.
In order not to affect the normal start of the car, it is recommended to set the protection level at
"H" when using the refrigerator in the car.
Battery
protection
9.6VLow grade - L
12 V
turn off
24 V
turn off
12 V
Turn on
24 V
Turn on
Medium - M
High grade-H
10.4V
11.1V
10.9V
11.7V
12.4V
21.3V
22.8V
24.3V
22.7V
24.2V
25.7V