7
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | info@tempo.org
Getting Started
Unpacking
Carton: This product has been packaged to protect it against transportation
damage. Unpack the appliance and keep the original packaging carton and
materials in a safe place. It will help prevent any damage if the product needs
to be transported in the future, and you can use it to store the appliance when
it is not in use. In the event that the packaging materials are to be disposed of,
please recycle them where possible.
Plastic wrapping can be a suffocation hazard for babies and young children, so
ensure all packaging materials are out of their reach and disposed of safely.
Cord: Unwind the cord to its full length and inspect the cord and the plug for
damage. Do not use the heater if the appliance or its cord has been damaged
or is not working properly. In case of damage, contact our after sales support
centre for advice on examination, repair or return of the damaged product.
Documentation: Make sure you have read and understood all instructions and
warnings in this manual. Refer to the Product Overview, page 6, to familiarise
yourself with the product and identify all parts. Pay particular attention to the safety
instructions on the previous pages.
Castor wheels: The heater is packaged with the feet (castor wheel assemblies)
unattached. You must attach them before turning on the heater.
Assembly
The heater must only be operated in an upright position with two castor wheel
assemblies fitted to the bottom of the appliance. Each castor wheel assembly
consists of a wheel plate and two castors.
Unpack all parts of the castor wheel assemblies.
Put a soft covering on a table or benchtop and carefully lay the heater on top with
the bottom end at the edge of the table.
Insert two castor wheels each through each wheel plate, affixing them with the
butterfly nuts.
Slide the wheel plates in the correct positions at the underside of the heater.
Secure the wheel plates by tightening the butterfly nuts.
Turn the heater in upright position after the castor wheels are properly fitted.
WARNING!
• Do not operate the heater without the castor wheel assemblies attached.
• Only operate the heater in an upright position (wheels on the bottom,
controls at the top), any other position could create a hazard.
To Next Page
Loading...
