8
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | info@tempo.org
Operating Instructions
Location
The heater is for floor-standing use only. Place it in an upright position on
a firm, level, dry and heat-resistant floor surface, taking into considering all
relevant safety information on the previous pages.
Ensure that there is sufficient distance from the wall, fixtures, furniture and
other appliances. To exclude the risk of fire, ensure there are no flammable or
heat sensitive materials or substances within 1m of the heater.
Connection
Plug the heater into an appropriate electrical outlet and switch on power to the
outlet. Always use a separate socket that has no other appliances connected
at the same time – do not plug it into a power board or socket adaptor; do not
use an extension cord. Also ensure that the socket is easily accessible so that
the cord can readily be disconnected in an emergency.
To turn on the heater, select a power setting and set the thermostat to your
desired heat level/temperature.
Power settings
OFF......Power off
I ...........Low power (800W) Only the top quartz tube will be on.
II ..........Medium power (1600W) The top and bottom quartz tubes will
be working.
III ..........High power (2400W) All three quartz tubes will be working
without the fan function.
.......High power (2400W) with fan All three quartz tubes will be
working together with the fan to help
distribute the warm air.
Thermostat control
The heater is equipped with a thermostat so you can maintain the room
temperature at the set level when running the heater on high power. It only
regulates the temperature on the settings III and .
With the thermostat set to the minimum position, the heater stops working
when the ambient temperature is around 15°C. When the ambient temperature
drops below 15°C, the appliance starts heating on settings III and until the
temperature rises above 15°C. To continue heating at this stage you will have
to adjust the thermostat control to a higher setting.
To Next Page
Loading...
