A
.A
0ff
ON~
0
1
11
Preparing the machine
Attaching the foot control
Plug foot control into machine
socket (A) and then into main
socket (8).
Sewing !!peed
The sewing speed can be
adjusted by increasing or
decreasing the pressure on the
foot
control(C).
Assembling the thread stand
Raise the support rod fully,
turning slightly until tile
positioning catches engage.
Thread cones
The anti-vibration cone should
be used with the wider edge
to
the
bottom on the
spool holder
pin when sewing with cones.
When using
household spools
remove the anti-vibration cones.
Place spool on spool holder pins
and push the
spool caps on.
If threads slip and get twisted,
cover the
spools with the nets
supplied
in
the accessory box.
Powerllight switch
The power switch
is
conveniently
placed on the handwheel side of
the machine.
"I" -
ON
"
0"
- OFF
To Next Page
Loading...