J
t
15
Using the machine
Inserting needles
- Switch the machine o
ff
"0".
Disconnect machine from
electricity supply.
- Turn the handwheel until needles
are
fully raised.
- Lower the presser foot.
- Use the hexagon wrench
to
loosen the needle setscrew.
Remove needle.
-
Insert the needle flat side
towards the back, as far
as
possible into the needle clamp.
Tighten
th
e screw.
- The left needle
is
set higher than
the right needle.
Raising the
upper
knife
- Turn the handwhee l to raise the
needles.
-
Open
th
e looper cover.
- Press the upper knife
hOlder'to
the right. Turn the
kn
ob
clockwise
until the knife engages.
- Close the looper cover.
To lower the upper knife:
- Turn the knob anti-clockwise.
The knife snaps automatically
into its lower position, Close the
looper cover.
To Next Page
Loading...
