LS Series Coolers and Condensers
4
The recommended method for extended lifts is to use slings under the unit as shown in Figures 5 and 6. Spreader bars should
always be used between the cables at the top of the section to prevent damage to the upper flanges. NOTE
: The U-bolts or other
lifting points should be used for final positioning only and for lifting where no danger exists. If they are used for extended
lifts, safety slings and spreader bars should be provided under the sections as shown.
Figure 5 – Extended Lift Pan/Fan Section
(up to 5.4m Long)
Figure 6 – Extended Lift Pan/Fan Section
(7.3m and 11m Long - 6 lift points shown)
See Table 2 for the minimum “H” dimensions for rigging the pan-fan assembly for both standard and extended lifts.
To Next Page
Loading...
