PAGE
01/02
www.evb.com
1. Safety Information
evb.com
2. Product Introduction
evb.com
Important Safety Instructions
This document contains important instructions and warnings that must be followed when installing and maintaining the EV Charger.
Read this entire mandatory document before installing or using the EV charger.
This device should be supervised when used around children.
The BCP series EV Charger must be grounded through a permanent wiring system or an equipment grounding conductor.
Do not install or use the EV Charger near flammable, explosive, harsh, or combustible materials, chemicals, or vapors.
Use the EV Charger only within the specified operating parameters.
Never spray water or any other liquid directly at the wall mounted EV Charger. Never spray any liquid onto the charger handle or
submerge the charger handle in liquid. Store the charger handle above the ground to prevent unnecessary exposure to contamination
or moisture.
Stop using and do not use the EV Charger if it is defective, appears cracked, frayed, broken, or otherwise damaged, or fails to operate,
or continue operation.
Do not attempt to disassemble, repair, tamper with, or modify the EV Charger. The EV Charger is not user serviceable. Contact us for
any repairs or modification.
Transporting the EV Charger, handle with care. Do not subject it to strong force or impact or pull, twist, tangle, drag, or step on the EV
Charger, to prevent damage to it or any components.
Do not touch the EV Charger’s end terminals with sharp metallic objects, such as wire, tools, or needles.
Do not forcefully fold or apply pressure to any part of the EV Charger or damage it with sharp objects.
Do not insert foreign objects into any part of the EV Charger.
Use of the EV Charger may affect or impair the operation of any medical or implantable electronic devices, such as an implantable
cardiac pacemaker or an implantable cardioverter defibrillator. Check with your electronic device manufacturer concerning the effects
that charging may have on such electronic devices before using the EV Charger.
Warning
Cautions
Do not use private power generators as a power source for charging.
Incorrect installation and testing of the EV Charger could potentially damage either the vehicle's Battery and/or the EV Charger itself.
Any resulting damage is excluded from New Vehicle Limited Warranty and the EV Charger Limited Warranty.
Do not operate the EV Charger in temperatures outside its operating range of -25°C to +55°C.
That adaptors or conversion adapters are not allowed to be used.
That cord extension sets are not allowed to be used.
Notes
Ensure that the EV Charger's charging cable is positioned so it will not be stepped on, driven over, tripped on, or subjected to damage
or stress.
Do not use cleaning solvents to clean any of the EV Charger's components. The outside of the EV Charger, the charging cable, and the
connector end of the charging cable should be periodically wiped with a clean dry cloth to remove accumulation of dirt and dust.
Be careful not to damage the circuit board when removing the power entry knock-out.
2.1. Product Appearance
1
4
2
3
5
6
1
2
3
4
5
6
Logo
Emergency Button Switch (When the button is pressed, the EV Charger will stop, then rotate the button pop-up reset.)
Function test button
(For WPS connection, and leakage test.)
RFID
Type 2 socket
LED light
To Next Page
Loading...