EVCO S.p.A.
c-pro 3 micro CHIL | Application manual ver. 1.0 | Codice 144CP3CHE104
page 19 of 120
6.8 Installer Menu
The installation menu is a Level 3 menu, i.e. it requires entering of the installation level (or higher) password, in order to be able to
display/modify the parameters contained in this branch.
Display LCD Display LED
COMPRESSORS CoMP
REGULATION rEG
FANS FANS
DEFROST dEFr
PUMPS PuMP
ANTI-FREEZE A-F
FREE-COOLING F-C
SAFETIES SAFE
MODBUS MdbS
VARIOUS Par
SAVE/RESTORE MAp
PASSWORD PSd3
The installation operator menu contains all the parameters connected with the configuration of all functionalities (alarms, settings,
logic, rotation type, etc.) of the machine.
In the REGULATION menu, it is possible to set the parameters connected with lateral-band and zero energy band temperature control
of compressors.
In the COMPRESSORS menu, it is possible to set the parameters connected with the management of devices:
• rotation
• timings
• maximum number of start-ups.
In the FANS menu, it is possible to set the parameters connected with the control of condensation pressure, via the fans.
In the DEFROST menu, it is possible to set the parameters connected with the activation and duration of heat pump defrosting.
In the PUMP menu, it is possible to set the parameters connected with operation and protection of pumps.
In the ANTI-FREEZE menu, it is possible to set the parameters connected with the thermal control of resistors and control of the anti-
frost alarm.
In the FREE-COOLING menu, it is possible to set the parameters connected with free-cooling function and damper.
The SAFETIES DEVICES menu contains all parameters connected with alarms and management of safety devices which protect the
refrigerating circuit:
• activations
• reporting delays
• type of resetting.
In the MODBUS menu it is possible to set the parameters connected with modbus.
The VARIOUS PARAMETERS menu contains other general parameters connected with the management of Modbus communications,
transducer full-scale values and other configurable activations.
From the SAVE/RESTORE menu it is possible to restore the default values of all parameters of the application and save or download
from the programming key or internal controller memory.
To Next Page
Loading...
