EVCO S.p.A.
c-pro 3 micro CHIL | Application manual ver. 1.0 | Codice 144CP3CHE104
page 44 of 120
8 REGULATIONS
8.1 Machine Status
Several procedures exist for switching the unit ON and OFF:
1) Using the dedicated ON/OFF key (this function is enabled via parameter PH05).
Switching ON – Press the dedicated key for about 2 seconds: if all other enabled functions are present, the machine switches
itself ON.Switching OFF – Press the dedicated key for about 2 seconds: the machine switches itself OFF.
2) Using the ON/OFF command from digital input (this function is enabled via parameter PH07).
Switching ON – Close the remote ON/OFF contact: if all other enabled functions are present, the machine switches itself ON.
Switching OFF – If the remote ON/OFF contact reveals itself to be open, the machine switches itself “OFF from digital input”,
which is indicated by “OFF D”.
3) Using a supervisory protocol (this function is enabled via parameter PH09).
Switching ON – Activate via protocol the switching ON status: if all other enabled functions are present, the machine switches
itself ON.Switching OFF – If the ON status is disabled via protocol, the machine switches itself “OFF by supervisory protocol”,
which is indicated by “OFF S”.
4) Using a schedule (this function is enabled via parameter PH16).
Switching ON – If the date and time of the RTC indicates an ON status: if all other enabled functions are present, the machine
switches itself ON.Switching OFF – If the date and time of the RTC indicates an OFF status; the machine switches itself OFF.
OFF statuses from digital input, supervisory protocol and schedule are only accessible if the machine has been enabled by key press.
The machine ON/OFF key is the ESC key.
To Next Page
Loading...
