EVCO S.p.A.
c-pro 3 micro CHIL | Application manual ver. 1.0 | Codice 144CP3CHE104
page 82 of 120
8.22 Resetting of default parameters
Using the “Parameter resetting” procedure, all system parameters can be reset to their original default values. After entering the InSt-
>MAP menu – which is only accessible while the machine is switched OFF – set parameter PH15=1 and wait for the “0” value to
reappear on the display; the system will automatically reset all parameters back to their default values.
After this operation, it is necessary to power down the machine and then power it up again, to avoid the risk of malfunctions.
8.23 Parametering key
The values of all system parameters can be saved on the parametering key USB, to be subsequently copied to one or more compatible
devices, or in a dedicated area in controller memory. This function is available from the menu Installer->Parameters Map.
Display LCD
Display LED
PH15 0/1
SAvE USb
rESt USb
SAvE MEM
rESt MEM
Note: Information relating to the product and product version is stored onto the parametering key, thus allowing the transfer of
parameter maps only between devices which are compatible with one another.
To Next Page
Loading...
