Evco c-pro 3 nano Series User Manual

EVCO S.p.A. c-pro 3 nano | Hardware Manual ver. 1.0 | Code 114CP3NE104
page 15 of 26
8 List of hardware parameters
The table below shows the hardware parameters of the device. The hardware parameter values are overwritten by the parameter values of the application software.
Text in italics indicates the way the labels appear on a graphic display, for example on a remote user interface.
No. SUB-MENU PARAMETER DEFAULT DESCRIPTION MIN... MAX.
1
InFo
Info
Pr n
PROJ NUM
- - - - application project number read-only parameter
2
InFo
Info
Pr u
PROJ VER
- - - - application project version read-only parameter
3
InFo
Info
Pr r
PROJ REV
- - - - application project revision read-only parameter
4
InFo
Info
FU u
FW VER
- - - - firmware version read-only parameter
5
InFo
Info
FU r
FW REV
- - - - firmware revision read-only parameter
6
InFo
Info
FU S
FW UND
- - - - firmware sub-revision read-only parameter
7
InFo
Info
HU u
HW VER
- - - - hardware version read-only parameter
8
InFo
Info
HU r
HW REV
- - - - hardware revision read-only parameter
9
InFo
Info
SPEc
SPEC
- - - - type of hardware (G general; S special) read-only parameter
10
InFo
Info
SU u
SW VER
- - - - UNI-PRO 3 version read-only parameter
11
InFo
Info
SU r
SW REV
- - - - UNI-PRO 3 revision read-only parameter
12
InFo
Info
SU S
SW UND
- - - - UNI-PRO 3 sub-version read-only parameter
13
InFo
Info
Sn
SN
- - - - serial number read-only parameter
14
InFo
Info
tESt
Test
- - - -
information concerning production testing and
calibration
read-only parameter
15
InFo
Info
MK n
MASK N
- - - -
mask number (according to the manufacturer's
coding system)
read-only parameter
16
InFo
Info
MK u
MASK VER
- - - -
mask version (according to the manufacturer's
coding system)
read-only parameter
17
InFo
Info
MK r
MASK REV
- - - -
mask revision (according to the manufacturer's
coding system)
read-only parameter
18
InFo
Info
dAtE
date and time
- - - -
date and time the application project was last
compiled
read-only parameter
19
PAr
Parameters
AI 1
AI 1
ntC
NTC
type of probe analogue input 1
ntC = NTC
NTC
0-20 = 0-20 mA
0-20mA
4-20 = 4-20 mA
4-20mA
0-5 = 0-5 V ratiometric
0-5V
0-10 = 0-10 V
0-10V
rES = electric heater reading
RESIST
nA = not available
nA

Evco c-pro 3 nano Series Specifications

General

Brand	Evco
Model	c-pro 3 nano Series
Category	Controller
Language	English