Evco c-pro 3 nano Series User Manual

EVCO S.p.A. c-pro 3 nano | Hardware Manual ver. 1.0 | Code 114CP3NE104
page 14 of 26
To download the device configuration using a USB flash drive proceed as
follows.
1.
Connect a USB flash drive to the device as shown in the section
USB flash drive connection.
2. Touch the DOWN key for 4s.
The display will show
Upper line MEnu
Lower line InFo
3.
Touch the UP or DOWN key to select the sub-
menu “Strd”.
The display will show
Upper line Menu
Lower line Strd
4. Touch the SET key.
5. Touch the SET key again.
6. Touch the UP or DOWN key to set “-19”.
7. Touch the SET key.
The display will show
Upper line PAr (device parameters)
Lower line KEY
7’.
Touch the UP or DOWN key to select the label
“bK”.
The display will show
Upper line bK (device backup memory)
Lower line MEM
8. Touch the SET key.
The display will show
Upper line Key (or MEM)
Lower line APPl (application software parameters)
8’.
Touch the UP or DOWN key to select the label
“HU”.
The display will show
Upper line KeY (or MEM)
Lower line HU (hardware parameters)
9. Touch the SET key.
10. Touch the UP or DOWN key to select “SAvE”.
The display will show
Upper line SAvE
Lower line OK
11. Touch the SET key again.
The information will be downloaded to the USB flash drive. This
operation normally takes a few seconds. If there is an error the
system alarm LED will light up.
12. Disconnect the USB flash drive from the device.
13.
Touch the ON/STAND-BY key a few times to
return to the main display.
To upload the device configuration using a USB flash drive proceed as follows.
1.
Connect a USB flash drive to the device as shown in the section
USB flash drive connection.
2. Touch the DOWN key for 4s.
The display will show
Upper line MEnu
Lower line InFo
3.
Touch the UP or DOWN key to select the sub-
menu “Strd”.
The display will show
Upper line Menu
Lower line Strd
4. Touch the SET key.
5. Touch the SET key again.
6. Touch the UP or DOWN key to set “-19”.
7. Touch the SET key.
The display will show
Upper line PAr (device parameters)
Lower line KEY
7’.
Touch the UP or DOWN key to select the label
“bK”.
The display will show
Upper line bK (device backup memory)
Lower line MEM
8. Touch the SET key.
9. Touch the UP or DOWN key to select “rESt”.
The display will show
Upper line rESt
Lower line oK
10. Touch the SET key again.
The information will be uploaded to the USB flash drive. This
operation normally takes a few seconds. If there is an error the
system alarm LED will light up.
11. Disconnect the USB flash drive from the device.
12.
Touch the ON/STAND-BY key a few times to
return to the main display.

Evco c-pro 3 nano Series Specifications

General

Brand	Evco
Model	c-pro 3 nano Series
Category	Controller
Language	English