Evco EV3K11 User Manual

EVCO S.p.A. EV3 MVC & EVD MVC | Application manual ver. 1.0 | Code 144EV3MVI104
page 13 of 72
To be installed on a panel with snap-in brackets provided.
The thickness of the panel on which the EV3K11 is to be installed must be between 0.8 and 2.0mm (0.031 and 0.078 in).
3.4 Measurements and installation of EVJ LCD
The pictures below show the measurements of EVJ LCD; measurements are expressed in mm (inches).
To be installed on a wall (with fixing screws and plugs) or in a 502E or 503E built-in box (with fixing screws).
3.5 Installation precautions
- Ensure that the working conditions for the devices (operating temperatures, humidity, etc.) are within the set limits. See the
section TECHNICAL SPECIFICATIONS.
- Do not install the devices close to heat sources (heaters, hot air ducts, etc.), equipment with a strong magnetic field (large
diffusers, etc.), in places subject to direct sunlight, rain, damp, excessive dust, mechanical vibrations or shocks.
- In compliance with safety regulations, the devices must be installed properly to ensure adequate protection from contact with
electrical parts. All protective parts must be fixed in such a way as to need the aid of a tool to remove them.

Evco EV3K11 Specifications

General

Brand	Evco
Model	EV3K11
Category	Controller
Language	English