5
1. STOP! Read the safety information above on this label.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device which
burner by hand.
5. Remove control access panel.
6. Slightly depress the gas control lever and move it right
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to be performed.
3. Remove control access panel.
5. Replace control access panel.
B. BEFORE OPERATING smell all around the appliance area for gas. Be sure
to smell next to the floor because some gas is heavier than air and will
settle on the floor.
Do not try to light any appliance.
Do not touch any electric switch; do not use any phone in your building.
Follow the gas supplier’s instructions.
If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the gas control knob. Never use
tools. If the knob will not push in or turn by hand, don’t try to repair it,
call a qualified service technician. Force or attempted repair may result
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the appliance
and to replace any part of the control system and any gas control
which has been under water.
automatically lights the burner. Do NOT t ry to light the
4. Slightly depress gas control lever and move it right to the “OFF” position.
WHAT TO D O IF YOU SMELL GAS
in a fire or explosion.
11. Set thermostat to desired setting. Burner will light which may take 30---60 seconds.
12. If burner fails to light, set thermostat to below room temperature.
WAIT ONE (1) MINUTE, and then reset thermostat to try again for ignition.
Immediately call your gas supplier from a neighbor’s phone.
7. Wait five (5) minutes to clear out any gas. If you then
smell gas, STOP! Follow “B” in the safety information
above on this label. If you don’t smell gas, go to next step.
8. Move the gas control lever left to the “ON” position.
9. Replace control access panel.
10. Turn on all electric power to the appliance.
13. After three (3) trials for ignition, if the appliance will not operate, follow instructions
“TOTURNOFFGASTOAPPLIANCE”and
to the “OFF” position.
call your service technician or gas supplier.
VALVE
REGULATOR
PRESSURE
CONVERTER
GASCOCK
LEVER
(RED)
ROBERTSHAW