To Next PageTo Next Page
Need help?Do you have a question about the Evcon DLAS075BDD and is the answer not in the manual?
General| BTU | 75, 000 |
|---|---|
| Efficiency | 80% |
| Blower Motor | Multi-speed |
| Ignition Type | Hot Surface Ignition |
| Heat Exchanger Material | Aluminized Steel |
| Stages | Single-stage |
Details model input/output BTUH and factory fuel type.
Lists voltage, amperage, and circuit requirements.
Emphasizes adherence to all local codes and regulations.
Specifies required distances from combustible materials.
Details derating requirements for elevations above 2,000 feet.
Outlines requirements for return air in closet installations.
Details requirements for floor/ceiling return air systems.
Specifies minimum free area and clearance for closet doors.
Guides on proper placement and cutting for roof jack installation.
Details the procedure for securing the roof jack to the roof.
Describes the purpose and use of ceiling rings for fire stopping.
Explains the design and installation of duct connectors.
Provides dimensions for cutting openings for duct connectors.
Step-by-step guide for installing the DLAS series furnace.
Step-by-step guide for installing DGAT & DGAM series furnaces.
Instructions for replacing an old furnace vent system.
Guidelines for installing vent systems in new homes.
Recommendations for snow-prone areas.
Details the process of connecting the main power supply.
Explains how to connect thermostat wiring to the furnace.
Provides guidance on thermostat placement and selection.
Covers sizing, installation, and leak detection of gas lines.
Instructions for checking flame appearance and operation.
Explains combustion air adjustment for efficient burning.
Lists checks for furnace operation issues.
Covers final steps like installing doors and finishing trim.
