20
Locking Clip
installed properly.
4. Remove all slack
from the seat belt.
Push downward on child
restraint while tightening
seat belt to remove
excess slack.
Installation with Seat Belt
Some ELR vehicle belts can be switched so that they lock
when tightened. It may not be necessary to use a locking
clip in these situations.
Consult your vehicle owner’s manual before
installing the locking clip.
To see an example of seat belt types and to properly
install a locking clip, go to p. 37.
5. Install locking clip,
if necessary.
You MUST use a locking
clip if your vehicle has:
Lap/shoulder seat belt
combination that has
a buckle tongue that
slides freely along the
belt without locking
into place, OR seat belts
equipped with an emer-
gency locking retractor
(ELR).
To Next Page
Loading...
