Evenflo SONUS - Forward-facing Installation with Seat Belt; Forward-facing Seat Belt Setup

36 37
Shoulder harness straps on this child restraint are
adjustable to six positions.
U.S. Customers Only: Rear-facing, the shoulder harness
straps MUST start at or below shoulder height using the
strap slots closest to your child’s shoulders in one of the
four lower harness positions
A
and
B
. The child’s head
MUST be at least 25 mm (1 inch) below the top of the
seat back.
Canadian Customers: Rear-facing, the shoulder harness
straps MUST start at or below shoulder height using the
strap slots closest to your child’s shoulders in one of the
three lower harness positions
A
. The child’s head MUST
be at least 25 mm (1 inch) below the top of the seat back.
U.S. and Canadian Customers: Forward-facing, you
MUST use one of the top three harness positions
B
and
C
. If the tops of the child’s ears are above the top of the
seat back, or the child’s shoulders fall above the upper
harness slots, you MUST discontinue use of this child
restraint. We recommend that you move your child to a
larger child restraint or a booster seat. You MUST use the
harness slots at or above the child’s shoulders AND closest
to your child’s shoulders.
Positioning the Harness Strap
Forward-facing ONLY
Top Two Harness
Positions
U.S. and Canadian
Customers:
Rear-facing ONLY
Bottom Three
Harness Positions
A
C
1
2
3
D
U.S. Customers
ONLY:
Rear-facing and
Forward-facing
This set of harness
slots can be for either
forward-facing or
rear-facing use.
Canadian
Customers:
This set of harness
slots can ONLY be
used forward-facing.
There are two positions on the harness straps. The top
loop
E
is for infant use. The bottom loop
F
is for use as
your child grows. Reattach the harness strap onto the
splitter plate
D
. Repeat on the other side.
IMPORTANT: Make sure both harness straps are
installed completely on the splitter plate, as shown.
D
F
Child
D
E
Infant
Child
Infant
To change the
harness strap
position, loosen the
shoulder harness as
shown on page 41,
step 2. Slide the
harness strap off the
splitter plate
D
.
Pull harness strap
through to the front of
the child restraint.
Thread each harness
strap through the
appropriate slot. Pull
the harness strap to
the back of the child
restraint.
B
General
General Information