34 35
Using the Locking Clip
Adjusting the Harness Strap
1
To tighten the harness
straps, pull on the long
harness adjuster strap A
on the front of the seat.
To loosen the harness
straps, push the harness
release lever B on the front
of the seat. At the same
time, pull up on the harness
strap C near the child’s
shoulders.
2
A
B
C
Adjusting the Crotch Strap
To reposition the crotch strap, first turn the child
restraint upside down. Turn the crotch strap harness
anchor A sideways and push it through the slot in
the bottom of the seat shell B.
Reposition the harness anchor into the other slot.
Make certain the harness anchor is properly seated
against the seat shell B.
Note: The crotch strap should be snug against the
child; choose the slot that is closest to the child AND
the most comfortable for the child.
This Child Restraint Has Two Buckle Harness Positions
A
B
A
General
Information
Using your full weight, press down on the child
restraint as you tighten the seat belt.
While holding the lap and shoulder belts together
just behind the free sliding buckle tongue A,
unfasten the seat belt.
Rear-facing
Installation
Forward-facing
Installation
A
1
• Lap/shoulder seat belt
combinations that have a
buckle tongue that slides
freely along the belt with-
out locking into place; OR
Locking Clip
Use the locking clip with:
T
o view a video about installing a locking clip, go to
www.evenflo.com
.
• Seat belts equipped with an emergency locking
retractor (ELR). Some ELR vehicle belts can be switched
so that they lock when tightened. It may not be
necessary to use a locking clip in these situations.
Consult your vehicle owner’s
manual before installing the
locking clip.
A
To Next Page
Loading...
