Even-GLO™ Series GA301
Page 35
October-28-15
Installation Instructions(Models GA301-M, GA301-MP)
Position / Move the Heater
1. Ensure Wheels are properly connected to the Bottom Base.
2. Move the Heater by handling ONLY the Pole. It may take two people to
manoeuvre the Heater safely depending on the size / strength of the person(s).
3. Tip the Heater backwards at an angle to / overtop of the wheels until Base no
longer touches the ground. Wheel Heater to the desired new location and return
Base to ground. Ensure Heater is on level ground and stable in new location.
4. If the Heater is going to be operated at the new location, the “Start-Up
Procedure” must be completed.
To Next Page
Loading...