Even-GLO™ Series GA301
Page 40
October-28-15
Maintenance & Troubleshooting Instructions
Maintenance instructions for models GA301, GA301-H & GA301-T:
•
Before performing any service shut off gas and electric supply.
•
Check condition of burner, especially integrity of flame screen.
•
Inspect condition of spark and sense electrode. Check for cracks in ceramic
insulators or excessive corrosion.
•
Inspect condition of high tension lead to spark rod.
•
Annually verify hose gas supply in heater post and all connections for gas leaks.
Troubleshooting instructions for models GA301, GA301-H &
GA301-T:
No Gas Supply at Burner
•
Ensure manual shut off valve is in proper position
•
Ensure there is pressure and flow at inlet to gas valve.
•
Ensure gas valve gets 24v power from control module during ON cycle.
No Spark
•
Ensure control module has 24VAC supply
•
Ensure spark electrode assembly is grounded and there are no cracks in ceramic
insulator.
Flame Lights but Will Not Stay Lit
•
Ensure there is no overpowering wind.
•
Ensure sense electrode is not corroded, is not grounded or has a cracked
insulator. Electrode position is radially across face of burner.
To Next Page
Loading...