ELECTRICAL CONNECTIONS
LOCAL AUTHORITY REQUIREMENTS
Installation is only permitted by a licensed electrician and must be carried out according to instructions
provided by the manufacturer. Incorrect installation might cause harm and damage which the
manufacturer accepts no responsibility.
ELECTRICAL INSTALLATION FOR THE LICENSED ELECTRICIAN
This oven must be connected to a 220-240V 50Hz power supply. It must be earthed via the supply cord.
Before carrying out the connection to the power supply, the voltage rating of the appliance (stamped on the appliance
identification plate) must be checked for correspondence to the available mains supply voltage, and the mains electric
wiring should be suitable for the oven’s power rating (also indicated on the appliance identification plate). Use a
suitable electrical cable (wires minimum area1.5mm²) and a circuit breaker with a contact opening of at least 3mm
must be installed in the supply circuit.
The switched outlet must be connected to a suitable earth wiring, in conformity to current safety regulations.
The main’s switch should not be located above the appliance and no more than 1.25m away from it. The power supply
cord must not touch against any hot surfaces and must be placed so that its temperature does not exceed 75°C at any
point along its length.
After having installed the appliance, the switched outlet must always be in an accessible position.
NOTE: For connections to the mains power supply, never use adapters, reductions or multiple power points as these
may overheat and catch fire.
The mains terminal block is located on the back of the oven and the terminals are accessible by opening the terminal
block cover. Note: The back panel or terminal cover should not be opened when the mains power is still connected to
the appliance and never by an unauthorised person.
The electrical safety of this appliance can only be guaranteed if the oven is correctly and efficiently earthed. The
manufacturer declines all responsibility for damage resulting from an installation which has not been earthed correctly.
This appliance must be earthed. For this connection, a power lead of wire type H05VV-F should be used:
3x1.5mm² - 220-240V~
OVEN LAMP REPLACEMENT
The appliance must first be disconnected from the power outlet or turned off at your isolation switch.
Unscrew the glass cover attached to the lamp holder; anti-clockwise.
Unscrew the lamp and replace it with another high-temperature lamp with the following characteristics:
Type: G9
Voltage: AC220V-240V
Wattage: 25W
Temperature rating: 300°C
Remount the glass cover and reconnect the appliance to
the power supply
NOTE: Should you experience any difficulty please contact your nearest after-sales service centre.
To Next Page
Loading...
