INSTALLATION
The adjacent furniture must be able to withstand a minimum temperature rise of 110°C above the
ambient temperature of the room it is located in, during periods of use. The power supply to the
appliance must be cut off before any adjustments or maintenance work is done on it.
PREPARATION FOR INSTALLATION AND USE
Manufactured with best quality parts and materials, this modern, functional and practical oven will meet your needs
in all respects. Make sure to read the manual to obtain successful results so as not to experience any problems in
the future. The information given below contains rules that are necessary for correct positioning and service
operations. They should be read without fail, especially by the technician who will position the appliance.
CHOOSING A PLACE FOR THE APPLIANCES
There are several points to pay attention to when
choosing a place for your oven. Make sure to take into
account our recommendations below in order to
prevent any problems and dangerous situations,
which might occur later!
When choosing a place for the oven, attention should
be paid that there are no flammable or combustible
materials in the close vicinity, such as curtains, oil,
cloth etc. which quickly catch fire.
Furniture surrounding the oven or cooktop must be
made of materials resistant to temperatures above
110 C°.
Required changes to wall cabinets and exhaust fans
above a built-in cooktop as well as minimum heights
from the oven board are shown in the diagram.
Accordingly, a range hood should be at a minimum
height of 65 cm from the cooktop. If there is no range
hood the height should not be less than 70 cm. Refer to the range hood / cooktop instructions for specific details
before installation.
INSTALLATION OF BUILT IN OVEN
Insert the oven into cabinet pushing it forward fully. Open the
oven door and insert 4 screws into the holes on insides of the
oven frame and attach to the cabinet.
The dimensions and material of the cabinet in which the oven
will be installed must be correct and resistant to increases in
temperature. In a correct installation, contact with electrical or
insulated parts must be prevented. Insulating parts need to be
fitted in a way to ensure that they cannot be removed by using
any kind of tool. Installing the appliance in the close vicinity of a
refrigerator or a deep-freezer is not recommended as the
performance of the above-mentioned appliances will be
negatively affected due to emanating heat. After removing
your oven from its packaging, be sure that the oven is not
damaged. If you suspect any damage to the appliance, do not
use it; immediately contact an authorised Service Centre.
To Next Page
Loading...
