OPERATING INSTRUCTIONS
Note: Before the unit can be operated, it must either be ducted or, if the model is installed as a re-circulating
range hood, it must be fitted with charcoal filters.
Connect the plug into the power.
Below is a diagram of the light and fan functions, with an explanation of how the light and the fan functions
operate.
To operate the light, push the switch ① into “1” position to switch the light on, or into “0” to turn the light off.
To operate the fan, push the switch ② onto either:
1 – Low Fan Speed
2 – Medium Fan Speed
3 – High Fan Speed
0 – To turn the fan Off.
If your range hood does not function correctly when attempting any of the above, please ensure that your
power is on and functioning correctly. If the power seems to be functioning correctly in the house, there may
be a problem with the range hood. Please call your authorized service agent in this case to organise a
service call or replacement unit.
CLEANING
SAFETY PRECAUTION
Before cleaning your range hood or performing any maintenance, please ensure that the range hood is
turned off at the power point.
Do not use abrasive cleaners to clean the range hood. The use of warm soapy water and a cloth are
recommended.
Ensure that the range hood is cleaned regularly, as a build up of grease and fat may occur otherwise.
The filters on the range hood must be cleaned regularly to maintain efficiency, and prevent grease build up.
It is recommended that this is undertaken every 4 – 6 weeks, depending on frequency of use.
The filters can be cleaned with warm soapy water or a cloth, or they may be washed in a dishwasher. If
washed in a dishwasher, discolouration may occur to the mesh and frame.
Cleaning of the range hood must be performed as described above, otherwise there is a possibility of a fire
hazard due to grease and fat build up.
If the range hood is fitted with charcoal filters (for re-circulating) it is recommended that the filters be
changed every 3 – 4 months. Filter replacement will ensure correct function of the range hood, and ensure
that the air being re-circulated back into the room is clean.
7
To Next Page
Loading...
