ECOR960 4F2 / 8F2 / 16F2
What type of DVR are you installing? ______________
The default ports are
ECOR264: 80
Paragon: 80
ECOR: 80, 1600
EDR/EDVR: 80, 1600, and 37260 – 37263
EMV: 80
TUTIS: 80
If the ports were changed in the Network Setup, use those port numbers.
Pre-Installation
Everfocus’ DVR can operate using one of three types of networking connections.
Simple One to One Connection: A simple one to one connection is the simplest type of network
connection. It uses a cross-over cable to make a direct connection from one computer to another
(or in this case a computer to a DVR).
Direct High Speed Modem Connection: A direct modem connection uses a standard network cable
to connect the modem directly to a computer (or in this case a modem to the DVR). This type of
connection only covers single-port modems. For a combination modem/router, use the setup
described below.
Router or LAN Connection – A local area network connection requires either a router or a
pre-existing LAN connection. This is the most common type of connection. A router allows
multiple computers and DVR’s to access each other as well as the Internet. It assigns different
internal IP addresses to the computers.
To Next Page
Loading...
